Around 20% of your energy bills stem from heating the water you use. On top of that, the biggest energy drain is inefficient water systems that don’t work well. They end up costing you more money because they go on overdrive. This hurts you the most, especially during temperate months, because the heat tends to dissipate in the cold.
Thankfully, boosting the efficiency of your water system is so much easier than you can ever imagine. If you want to lower your energy bills, you must find ways to optimise your hot water system. You can get a new installation done by reputable experts like Rapid Hot Water or consider the following methods below to help you get the job done.
Drain Out the Water and Flush Out the Tank
It is typical for sediments like magnesium and calcium to build up over time inside your water heater’s tank. These settle in the bottom and harden, forcing your system to work even harder. As a result of the excessive work, your water system can overheat. You might end up seeing leaks and cracks. To prevent this from happening, you must drain the water in your tank and flush it out with clean, cool water to take away the nasty sedimentation.
For optimal results, you must do this at least once away. When you eradicate sediments, you help you water heat become more efficient. You lower your energy bills, and you prevent future machine problems that may result in even more costly repairs.
Provide Insulation for Your System
When heat dissipates, it escapes from both your water tank itself and your pipers. If you want your hot water system to do its job of giving you hot water, consider adding insulation to these vulnerable areas. Imagine, there’s nothing worse than being doused with cold water in the dead of winter because someone flushed the toilet or opened the sink in the kitchen!
Losing heat in these areas means your system works more to compensate for the heat loss. Because of this, your water heater keeps on running, consuming more power which you will see on your energy bills.
Fix Those Nasty Leaks
Tiny leaks are quite common, and they hurt your pockets. The more water leaks out from your system; then it has to make more effort to produce hot water. With a system that’s running on overdrive like this, you end up wasting more energy. Usually, leaks start in the water heater itself. Make it a part of your routine maintenance to inspect for leaks around your tank.
The most common leak culprits are the drain and temperature-pressure relief valves. Check all those, along with water pipes near your heater. You must also check the pipes in your bathrooms and kitchen. Be vigilant about doing leak checks because no leak is too small. It is typical for big problems to start small.
Lessen the Water Temperature
Most water systems come with a built-in thermostat, which tells your machine how hot it should heat the water. The higher the setting, the more your system works. If your hot water system feels too hot, you can reduce your settings in the thermostat.
Lowering it will keep your water temperature at its most optimal level while decreasing energy used on standby mode and helping lower your bills. Reducing the temperature means also reduces the mineral build-up, thereby extending your system’s life.
Minimise Hot Water Use
If you want to lower your energy bills and help extend the life of your system, then you can use less hot water. Try switching to cold water during warm, summer months. You can also use cold water for non-essential tasks. Doing these simple tweaks will take the burden off your water heater and your pocketbook.
It is quite easy to take your water heater for granted. You only notice it when something goes wrong. But why wait before it’s too late? When that happens, it means you will already be facing expensive repairs. Mitigate the issue by being vigilant in preventing any problems or call a professional service like Rapid Hot Water so you can sit back and relax while the problem gets fixed for you.
Author: Julian Carter